Need help? Go to www.weemote.com
13
DELETE TV/STB CODES
NOTE: You do not need to delete an existing TV
or SET-TOP code in order to replace it. Simply
enter the new code, TV or SET-TOP box you
wish to replace. This is described in the
Quickstart Installation Guide, Page 8 for TV’s
and Page 11 for Set-Top boxes.
To delete or clear a TV or SET-TOP box code:
STEP 1: Press the “TV” or “STB” button, de-
pending on which code you want to delete, for 3
seconds until the LED light flashes.
STEP 2: Enter the code 333 as follows:
Press the “100” button 3 times = 3
Press the “10” button 3 times = 3
Press the “1” button 3 times = 3
STEP 3: Press the “TV” or “STB” button, de-
pending on which code you want to delete, once
again. The LED light should flash three times
and then go out to complete the sequence.
Need help? Go to www.weemote.com
14
SETTING CHANNEL 3/4
In most cases, your SET-TOP box tuner is set to
run with your Television tuner set to channel 3.
In some cases, your SET-TOP box tuner may be
set to run with your Television tuner set to
channel 4.
If your system is set to use channel 3, then you
will not need to do anything further.
However, if your system is set to use channel 4,
you will need to do the following:
STEP 1: Press the “TV” button for about three
seconds until the LED light flashes.
STEP 2: Press the “CHANNEL UP” button (top
of long blue button) once.
STEP 3: Press the NUMBER “4” (Pink) button
once to complete the setup sequence. The LED
light flashes twice and then goes out.
Go back to Page 13 of the Quickstart Installation
Guide to finish your setup.
NOTE: To go back to channel 3, simply
repeat the steps above except that in STEP 3,
press the NUMBER “3” (Orange) button.
