Fobis Technologies weemote 2 Installation Manual Download Page 6

Page: 6 / 10

Need help? Go to www.weemote.com

STEP

TEST THE

TV CODE

1. Make sure your TV is turned off.

2. Point the weemote® at your TV and press the
Power (red) button. The TV should go on. Now,
check the volume up/down button as well as the
channel up/down button. If all these functions
work, then you have the right code for your TV.

If any of the functions above do not work, then
you will need to try another TV code. Go back
and repeat Step 6.

NOTE: When you are finished testing and you
are using a Set-Top box with your system, then
you will need to set the TV back to the correct
channel or video input (see Step 12).

STEP

LAST STEP FOR

LAST STEP FOR
TV ONLY USERS!

TV ONLY USERS!

1. Write the TV code down on the battery

sticker located behind the battery door.

2. If you are also using a Set-Top box, then

you will need to proceed directly to STEP

10.

3. Go ahead and reattach the Setup area

cover and battery cover. DO NOT OVER-

TIGHTEN THE SCREWS!!!

Need help? Go to www.weemote.com

STEP

SETTING YOUR

SETTING YOUR
SET-TOP CODE

SET-TOP CODE

1. Turn on your Cable Box , Satellite Receiver
or Personal Video Recorder.

Please note that TiVo and Replay (PVR) units
are considered Set-Top devices to the
weemote®. If you also have a Set-Top box with
these units, you only need to program in the
TiVo or Replay code as your STB setting.

2. Please refer to the CABLE, SATELLITE OR
PERSONAL VIDEO RECORDER CODES
listed in the Reference Guide. NOTE: CABLE,
SATTELITE AND PVR CODES ARE LISTED
SEPERATELY. If you cannot find your brand
listed there, then please refer to the Reference
Guide to search for your code.

3. Locate the first code for your brand Set-Top
device.

4. Press and hold the “STB” button for about
three seconds until the LED light begins to
flash.

5. Enter the Set-Top Code number. In our
example, we are using the Scientific Atlanta
code number 003.

6. Press the “1” button 3 times = 3
In this example, there is no need to use the
“100” and “10” buttons as the channel number
is below 10.

7. Press the “STB” button again to set the code.
The LED should flash three times and then turn
off to confirm that the code was entered.