Fobis Technologies weemote 2 Installation Manual Download Page 4

Need help?  Go to www.weemote.com

7

Before we begin to program in the channels,
here is a quick overview  on the 100, 10 and 1
buttons. These buttons allow you to program in
the channels and code/s you will need to setup
the weemote® 2.  You must remove the setup
cover in order to access these buttons.

Depending on which number you need, you
simply break down that number by 100’s, 10’s
and 1’s. For example, channel 294 would be
entered by pressing the 100 button twice (100
X 2), the 10 button nine times (10 X 9) and the
1 button four times (1 X 4). See diagram below.

And don’t worry about zeros - the weemote®
will add them in later. For example, if you need
to enter channel 07 or 007 to get channel 7,
just enter the number 7 (1 button seven times)
and the weemote® will handle sending channel
07 or 007.

HINT - ENTERING CHANNELS

HINT - ENTERING CHANNELS

HINT - ENTERING CHANNELS

HINT - ENTERING CHANNELS

HINT - ENTERING CHANNELS

Example:
To Enter Channel 294

NOTE: You must program at least one
favorite channel in order for the weemote®
to work!

100 10

1

2

9

4

PRESS - # TIMES

200 + 90 +  4  = 294

weemote

program

buttons

Need help?  Go to www.weemote.com

STEP

STEP

STEP

STEP

STEP

8

1. Press and hold the “FAV” button for about
three seconds until the LED light begins to flash.

2. Press the favorite channel button you wish to
program - in this example we are using the
(Green) Button Number “1” to program in
channel 127.

3. Press the following combination of the 100, 10

and 1 buttons.
A. Press the “100” button X 1 time = 100
B. Press the “10” button X 2 times = 20
C. Press the “1” button X  7 times = 7

6. Press the Favorite Channel (Green) Button
Number “1” again to complete the sequence. DO
NOT PRESS THE FAV BUTTON. Please check
the LED - it  should flash three times and then
go out to confirm that the channel has been
programmed. If it does not, try again.

To setup favorite channels 2-5, simply use the

steps above except that for Steps 2 and 6, you
would substitute the Green Number 1 button for
the other favorite channel button (2,3,4 or 5)
you wish to program.

For programming channels 6-10, please refer to
the reference guide.

PROGRAM YOUR

PROGRAM YOUR

PROGRAM YOUR

PROGRAM YOUR

PROGRAM YOUR

FAVORITE

FAVORITE

FAVORITE

FAVORITE

FAVORITE

CHANNELS

CHANNELS

CHANNELS

CHANNELS

CHANNELS

5

5

5

5

5

Summary of Contents for weemote 2











Reviews: