RTM X42.Modbus Installation Manual and Operating Instructions
09.12.2019
18
6
Configuration
6.1
Quick Start
-
Insert the battery into the EMGZ482T.Modbus transmitter module and secure with
both knurled screws. The screws must be tightened sufficiently otherwise, the
centrifugal forces caused by cage rotation could eject the battery.
o
Connect the 24VDC power supply of the machine if a version without battery
is used
-
Connect the EMGZ482R.Modbus receiver module and the gateway using a patch
cable.
-
Connect the gateway to the power supply (24 VDC)
-
Connect the EMGZ482R.Modbus receiver module to the power supply (24 VDC)
-
Switch on the power supply for both devices
-
The radio connection of the RTM X42 system is established automatically. This can
take approx. 5 to 10 seconds.
-
After system start and establishment of the radio connection, the display in the
receiver module, e.g., shows “Modbus V3.15”. This describes the currently loaded
firmware.
-
The RTM X42 system is now ready and can be configured.
