www.fmiproducts.com
125011-01B
18
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
Each log is marked with a number. These
numbers will help you identify the log when
installing (see chart on page 19). It is very
important to install these logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater.
Note: Your appliance may vary from model
shown but log placement will be the same.
1. Place fiber ramp-log in center on chassis
as shown in Figure 21. The fiber ramp-log
can be identified by its shape and much
lighter weight when compared to the other
logs.
2. The log must sit flat on the black sheet
metal and behind the left metal tab as
shown in Figure 22.
3. Place front left and right logs and rear log
as shown in Figure 23.
4. Place top left log as shown in Figure 24.
The bottom of the log is shaped to fit onto
the recessed areas of the front left log
and the rear log. The recessed areas are
painted yellow.
5. Place top right log as shown in Figure 24.
The bottom of the log is shaped to fit onto
the recessed areas of the front right log
and the rear log. The recessed areas are
painted yellow.
Figure 21 - Installing Log Set
Base Assembly
Ramp
Log
Rear Log
Grate
Prongs
Front
Right Log
Front Left
Log
Figure 23 - Installing Logs
Figure 22 - Installing Log Set
Ramp
Log
Metal
Tab
Figure 24 - Installing Logs
Top Right Log
Front Left
Log
Front
Right Log
Top Left Log
6. Place the small top right log as shown in
Figure 25, page 19. The bottom of the log
is shaped to fit onto the recessed areas of
the top right log and the front right log. The
recessed areas are painted yellow.
f i r e - p a r t s . c o m
