www.fmiproducts.com
125566-01C
17
INSTALLATION
Continued
2. Place left bottom log (#2) onto base as-
sembly as shown in Figure 22. See detail
in drawing for contour on bottom of log.
Log will fit over metal brackets and flat
onto base assembly
3. Place right bottom log (#3) onto pan
burner as shown in Figure 22.
Figure 21 - Installing Log #1
1
INSTALLING LOGS, EMBERS AND
LAVA ROCK
WARNING: Failure to posi
-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With heater set to Hi, check to
see if flames contact any log. If
so, reposition logs according to
log installation instructions in
this manual. Flames contacting
logs will create soot.
LTF(18, 24, 30)-SO SERIES LOG
PLACEMENT
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater or as identified for
use with the heater as shown in Figure 20.
Note: Each log is marked with a part number.
See page 40 for part numbers.
TF Series Burner System - Log
Compatibility Chart
Burner System
Models
Fiber Log
Models
Concrete
Log Models
TF18NV
TF18PV
LTF18-MO
LTF18-MM
LTF18-SO
LTF18-RS
TF2430NV
TF2430PV
LTF24-MO
LTF24-MM
LTF30-MO
LTF30-MM
LTF24-SO
LTF30-SO
LTF24-RS
LTF30-RS
Figure 20 TF Series Burner System- Log
Compatibility Chart
1. Place rear log (#1) on base assembly
as shown in Figure 21. Log will fit over
right end of burner and rest in middle of
U-burner.
Figure 22 - Installing Logs #2 and #3
Bottom of
Log #2
2
3
