INSTALLATION INSTRUCTIONS FOR PP100A
THERMOSTAT BLOWER ACCESSORY
Ù®±«²¼»¼
Ñ«¬´»¬
Carton Contents
1 Blower Accessory
4 #10 Screws
2 #8 Screws
NOTICE: Only install this blower
in the heater models listed on the
blower Carton
.
The thermostat
function will not work correctly in
other heater models.
NOTICE: If wall mounted, discon-
nect heater from gas supply and
remove from wall before install-
ing blower accessory. Contact
this. Follow all local codes.
WARNING: Blower acces-
sory must be grounded. Blower
comes with a three-prong,
grounding plug as shown in Fig-
ure 1. The plug is your protection
against electrical shock. Plug
it into a standard, three-hole,
grounded, outlet. If cord needs
replacing, use only a cord with a
three-prong, grounding plug.
CAUTION: Label all wires
prior to disconnection when
servicing controls. Wiring errors
can cause improper and danger-
ous operation.
ATTACHING BLOWER
ACCESSORY
Remove front panel from heater by re-
1.
moving four screws holding front panel
to cabinet.
2.
removing 2 screws for medium cabinet
Remove knockout plate from cabinet
4.
5.
snip two small tabs in front of plate. Move
4 until tabs in back snap apart. Discard
knockout.
6.
Thread power cord through knockout
7.
hole in back panel.
CAUTION: Do not plug power
cord into electrical outlet until
installation is complete.
Figure 1: Grounding Plug
Figure 2: Rear of Heater, Screws and
Blower Location
Save this manual for future reference/Guarde este manual para referencias furturas.
Õ²±½µ Ñ«¬
Þ´±©»® Ô±½¿¬·±²
Þ¿½µ
п²»´
www.tesstools.net
800 397 7553
