www.fmiproducts.com
126364-01A
17
INSTALLATION
Continued
POWER SUPPLY AND BATTERY
INSTALLATION
It is helpful to have a flashlight so you can
see the connections as described below. Lo
-
cate the battery power supply. It is the black
box with the red and black wires. Locate the
control module (see Figure 24). Connect the
battery power supply to the control module
by plugging the battery power supply to the
mating receptacle on the control module. The
receptacle is located on the side of the black
control module next to the word “SUPPLY”
which is molded in the control module’s black
housing (see Figure 24). Be certain to push
the plug fully into the receptacle. Install bat-
teries in the battery power supply and hand
held remote control.
Figure 24 - Control Module
S1 Button
Connect Battery Plug Here
Touch Pad Wire Harness
Touch Pad Control
Figure 26 - Touch Pad Control Cable
Figure 25 - Touch Pad Wire Harness and
Touch Pad Control
Figure 27 - Connecting end of Touch Pad
Cable
TOUCH PAD INSTALLATION
Locate the touch pad wire harness and the
touch pad control (see Figure 25). They are
shipped from the factory in the clear plastic
bag with your owner’s manual. Connect the
black plastic connectors together as shown
in Figure 26. Connect the remaining end
with the white plastic connector to the control
module in the socket marked TOUCH LED
(see Figure 27).
NOTE:
The touch pad includes a red LED
display light. If the LED remains on, the black
plug is connected upside down. You must
unplug the touch pad control from the touch
pad wire harness, turn over, and reconnect.
RE-PAIRING
IMPORTANT!
This appliance is shipped
with the remote control and control module
(receiver) paired. However, if more than one
Copreci brand electronic ignition system is to
be used within a home or showroom,
all but
one appliance must have the remote control
and control module re-paired in order for each
appliance to operate on a unique frequency.
For multiple appliances, on all but one follow
the instructions under
Re-Pairing
before mov-
ing to
Installing Logs
on page 19. For single
appliance installations, skip the RE-PARING
section and proceed to
Installing Logs
.
It is helpful to have a flashlight so you can see
