www.fmiproducts.com
126364-01A
25
OPERATION
Continued
OFF BUTTON
This button switches off the appliance. If it is
pressed and held for more than 40 seconds,
the configuration menu is accessed.
LEFT, MIDDLE AND RIGHT BUTTON
These buttons change their function as shown
by the on-screen labels. For some screens a
button may have no function and is inactive.
The active buttons for a particular screen are
initially lit for 5 seconds to indicate that they
are active.
MENU SYSTEM
The remote is organized by means of a menu
system.
After batteries are installed the first time, the
remote starts at the ''OFF'' screen ( it is pos
-
sible that the remote is locked in the ''OFF''
screen: to unlock it just press the button below
''Unlock'', and then ''OK''. See Figure 52).
Left
Button
Middle
Button
Right
Button
Figure 51 - Screen Changes
Bottom Row
Mon 00-02
Configuration
Pairing
Off
Yes
Back
Select
Off
0.5°C
Thermostatic
Gap Temp
Programming
The screen changes depending on the input
from the buttons, but the bottom row always
displays the button function labels (see Figure
64). The functions of each button depends on
the options available on the current screen
(except for the OFF button which has always
the same function).
Note:
The bottom row of the screen is
indicating buttons functionality. In this case:
•
LEFT (
) button decreases the flame level
•
MIDDLE (
) button increases the flame level
•
RIGHT (Back) button goes back to the
previous screen (see Figure 51).
And then
Figure 52 - Menu System
SWITCHING ON
IMPORTANT:
When lighting the pilot and
burner for the first time, air will be present in
the system that must be purged.
The lighting sequence may have to be re
-
peated 10 to 15 times before gas reaches the
pilot. This is normal.
To turn the system on, press “On” (left but
-
ton) and “OK” (middle button). A beep from
the control module will be heard and the
ignition process will start. This will take up
to 20 seconds. Note that while in operation
the signal bars will disappear for a few mo
-
ments. If the pilot and burner do not light,
press the “Off” button, wait 15 seconds then
repeat the ignition steps from the beginning
of this paragraph. Note: each ignition step is
accompanied by two short series of ignition
sparks at the pilot.
ADJUST MENU
Before using the remote, there are various
settings which should be made, such as the
date, the language, the autolock option and
the comfort temperature.
For doing this, press ''Menu'' and then press
''Select'' to chose ''Adjust Menu''. There the
options shown in Figure 66, can be set. To
change any of these settings use the down
arrow to select the feature and then press
"Select" and "Change" to change the setting.
