www.fmiproducts.com
125368-01D
19
INSTALLATION
Continued
Figure 27 - Correct LTF(18,24,30)-SO &
EMC Log Placement
18" Models
24" Models
30" Models
LTF(18,24,30)-MO & EMF SERIES LOG
PLACEMENT
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater or as identified for
use with the heater as shown in Figure 20,
page 17.
Note: Each log is marked with a reference num-
ber. See page 39 for reference numbers detail.
1. Place the rear log (#1) on base assembly
as shown in Figure 28. Log will fit over
right end of burner and rest in middle
of U-burner.
2. Place the middle log (#2) in front of ''U''-
burner and against the edges of plate as
shown in Figure 29.
1
Figure 28 - Installing Log # 1
Figure 29 - Installing Log # 2
''U'' -
Burner
Base
assembly
2
3. Place the front left log (#3) onto the base
assembly between the middle log and the
grate. The back of the front left log will
rest against the front of the middle log.
The notch in the end of the front left log
will fit around the grate bar. See Figure
30, page 20.
4. Place the front right log (#4) onto the base
assembly between the middle log and the
grate. The back of the front right log will
rest against the front of the middle log.
The notch in the end of the front right log
will fit around the grate bar. See Figure
31, page 20.
