www.fmiproducts.com
125996-01C
26
CLEANING AND MAINTENANCE
WARNING: Turn off fireplace
and let cool before cleaning.
CAUTION: You must keep
control areas, burners and
circulating air passageways of
fireplace clean. Inspect these
areas of fireplace before each
use. Have fireplace inspected
yearly by a qualified service
person. Fireplace may need
more frequent cleaning due to
excessive lint from carpeting,
bedding material, pet hair, etc.
Pilot
Burner
Figure 32 - Correct Pilot Flame Pattern
Ignitor/
Sensor
Sensing
Rod
OPERATION
Continued
NOTE: The module must be programmed to
the Remote Control transmitter.
•
To program the module (make sure the
system has power), locate the learn button
(Figure 31, page 5) on the module. Press
and release the learn button. There will
be a beep sound from the module. Then
press any button on the remote transmit-
ter. Once the module's internal receiver
accepts the transmitter code, there will
be a series of confirming beeps.
•
The remote system is ready for use.
BATTERY BACK-UP
This fireplace is equipped with a battery back-
up. If the power was to go out on the fireplace,
the battery back-up allows the fireplace to
remain operational. Make sure to periodically
check the condition of the four AA batteries
used for the battery back-up.
INSPECTING BURNERS
Check pilot flame pattern and burner flame
patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the
proper flame. Alterations may have occurred
during shipping and handling. The pilot is
located on right hand side of burner.
The flame must envelope 1/4" of top of the
ignitor/sensor and grounding stem.
If your pilot assembly does not meet these
requirements:
• Turn the adjustment screw marked PILOT
clockwise to decrease or counterclockwise
to increase the flame to proper size (see
Figure 29, page 24). Do not remove the
adjustment screw.
• see
Troubleshooting
, page 28
GLASS DOORS
WARNING: Handle glass
door panels with care. Do not
strike, slam or otherwise abuse
glass. Do not operate fireplace
with the glass door unlatched,
removed, cracked or broken.
WARNING: Do not use
abrasive cleaners as this may
damage glass. Use a nonabra
-
sive household glass cleaner to
clean glass. Do not clean glass
when hot.
