ENGLISH
11
Attention!
The appliance must be installed at level on solid surfaces. See pages 6-7 to
come up with
the most appropriate installation method for your ECONAT C-15.
1- Drill four 8 mm (5/16") diameter holes on the wall to the place where the unit will be
placed with the distances shown in Figure 1.
2- Insert the wall anchors supplied with the unit into the holes (Part #29).
3- With a star (Phillips) screwdriver, mount two of the L shaped legs on the wall using the
40 mm screws supplied with the unit (Part #18).
4- With the small (open end) wrench (Part #32), attach the other L-shaped bracket legs to
the heater as shown in Figure 2. Use the two 7.5 mm screws (Part #21). The female
threads are built into the heater housing.
5- Attach the heater brackets to the wall brackets using 8 mm bolts (Part #25), the 8 mm
cap nuts (Part #26), and the washers (Part #24) as shown in Figure 3. Tighten using the
large end (box end) of the supplied wrench.
6- You can adjust the unit's angle between a 0-45 degrees to achieve the optimal heating
effect (Figure 4).
7- Before operating the unit, recheck all the screws and bolts that they are tight. Be sure to
route the electrical cord so that it doesn't contact the heater housing.
3.5 Installation Instructions
