Operating instructions TSM-21
Status as of 12 / 2021
Page 5
1.3 Safety-related information for the user
These instructions contain the required information for the intended use of the device described herein.
They are directed toward technically qualified personnel.
Qualified personnel are people who have been authorized by persons responsible for the safety of the
system to execute the required activities and are able to recognize potential dangers and avoid them
based on their training, experience and instruction, as well as their knowledge of relevant standards,
regulations, accident prevention regulations and operating conditions (definition of skilled personnel
according to IEC 364).
Caution:
Danger due to electric voltage.
Non-observance can lead to death, serious bodily injury or property damage.
The following safety information is for your protection, the protection of third parties as well as the
protection of the device. You should therefore observe it under all circumstances.
Disconnect the power supply before installation or dismantling work, as well as when
changing a fuse or making changes to the setup.
-
Observe the valid accident prevention and safety regulations for your specific application.
-
Before commissioning, check whether the nominal voltage of the device agrees with the local
mains
voltage.
-
Emergency Stop mechanisms must remain active in all operating modes. Unlocking the
Emergency Stop mechanisms must not result in uncontrolled reactivation.
-
The electrical connections must be covered.
-
Protective conductor connections must be checked for perfect function after installation.
Operating environment
The device must not come into direct contact with water.
When changing from cold to warm environments, allow the device to temper for a few hours before
putting it into operation; otherwise, damage could occur due to condensation water.
Do not install the control device near devices which generate strong electromagnetic fields. The function
could be disturbed as a result.
Also avoid environments which are very hot, cold or wet.
Power supply
-
Only connect the device to a grounded mains socket with a mains voltage of
95-253 V~/50 Hz or 95-253 V~/60 Hz.
-
If you notice malfunctions, disconnect the device from the mains. Have the device
checked by qualified, skilled personnel, and repaired if necessary.
The device
-
For safety and licensing reasons (CE), it is not permitted to convert and/or modify
the device without authorization.
- The device meets the valid low-voltage and EMC directive.
