CONSTRUCTION
WING
On a flat surface place the wing halves together making sure they are in proper
alignment. Glue together the halves (CA works fine) Use activator for faster bonding.
After bonding the wings together take a sharp knife at a distance of 3” from the leading
edge and make a slot for the wing reinforcement carbon fiber flat. This is also the CG.
CA or FoamTac the rod in place and let dry making sure it is flush with the
wing.
At a distance of 10 inches from the outside edge of the left wing mark and cut a hole
for the servo then hot glue or Foam Tac the servo in place. Then mark a straight line
aileron control horn in place. The same is true for the right wing. Cut a hole for the
aileron servos the same size or slightly smaller for the servo at a distance of 225 mm
from the outside edge of the wing. Run the cables from the servo to the inside of the
