17
▆
Left and Right Gimbal Swap
The nV14 is able to switch stick functions as needed. When the nV14 is shipped from the factory the left
stick is set up for throttle, and as such will not return to the centre.
• note: Remember to change the stick mode in the software after changing the stick positions.
Remove the 2 hand grips and switch pads,
then remove all 10 screws on the bottom of the
transmitter apart from the screws in the finger
grips. lift gently to pull the cover apart.
2
4
Take out the assembly assembly and loosen
the screws marked in the figure.
5
Replace the back of the transmitter and tighten the
screws, then replace the grips.
3
1
Pad
Screw
Caution • Don't pull the front and back too
far apart to avoid damaging wires.
Do not
remove
this screw
left and right gimbals shown below for clarity.
left
Right
loosen
Tighten
as shown , attach the assembly, removed
from the left assembly to the right assembly, and
tighten the screws marked in the figure.
left
Right
left
Right
assembly
Open
assembly
