Nirvana
AFHDS 2A
10
▆
Before Use
Before operation, please follow the instructions in this chapter to install the battery and connect the device.
Danger
•
Use only the battery specified by the manufacturer.
Danger
•
Do not open, disassemble, or repair the battery yourself.
Danger
•
Do not squeeze, puncture, or touch the metal terminals of the battery.
Danger
•
Do not expose the battery to high temperatures or liquids.
Danger
•
Take care to prevent the battery from dropping, bumping or vibrating.
Danger
•
Store the battery in a dry, cool environment.
Danger
•
If the battery is damaged, stop using it immediately.
▆
Transmitter Battery Installation
1. unscrew both battery compartment covers from the transmitter handles.
2. Insert 2 18650 batteries into the battery compartments.
• Please pay attention to the positive and negative terminals of the
battery. The positive and negative terminals of the battery are installed
as shown. To the right.
3. Screw the battery compartment covers back into place.
▆
Receiver Installation
Installation：
1. Make sure the receiver is installed away from the motor, electronic governor or parts with excessive
electrical noise.
2. The receiver antenna should be kept away from conductive materials such as metal rods and carbon
fiber. Make sure there is at least 1 cm receiver and the conductive material.
3. Make sure that the two antennas of the receiver are fixed at 90 degrees to each other (as shown below).
Caution
•
Do not connect the receiver to the power supply during these steps to avoid damage.
90°
90°
90°
