13
▆
Pre-Flight Check
For safety follow the steps below before use:
1. Inspect the entire system to ensure that everything functions as expected.
2. Perform a range check: Move the transmitter and receiver apart until they lose connection.
Danger
•
If there is any strange behaviour during testing do not use.
Danger
•
When in use make sure not to fly beyond the maximum range.
Caution
•
External signal sources may affect signal quality.
▆
Power Off
Danger
• For safety always power off the receiver before the transmitter.
1. Power off the receiver.
• For safety always power off the receiver before the transmitter.
2. Press and hold both power buttons until the screen powers off.
Danger
•
Check each channel is working correctly before use.
▆
lanyard Eye and SD Card Slot
1. loosen the two hex screws on the back lanyard Eye
2. Remove the lanyard eye to expose the SD card slot.
3. Press the SD card inwards and release to remove.
• The nV14 needs to have an SD card installed for the
firmware to work correctly.
SD Card Slot
• The nV14 transmitter is compatible with FRSKY XJT, FRSKY R9M, SPEKTRuM, TBS CROSSFIRE and TBS
CROSSFIRE is making.
• When using the nV14's internal batteries, the transmit power should not exceed 100mW. If it is greater
than 100mW, an external power supply is required.
