FS-G7P
Digital Proportional Radio Control System
Website
24
7.FS-R7P Function Instructions
FS-R7P based on ANT protocol is a receiver which provides seven channels. It has an external
single antenna, can output PWM or PPM/i-BUS/S.BUS signal. It has a compact design. It can be
adapted to a variety of model cars or boats.
Note：See [2.3 Receiver Overview] for interface Introduction details.
•
Make sure the product is installed and calibrated correctly, failure to do so may result in
serious injury.
•
Make sure the receiver's battery is disconnected before turning off the transmitter, failure to
do so can result out of control.
•
Unreasonable setting of the Failsafe may cause accidents.
•
Make sure the receiver is mounted away from motors, electronic speed controllers or any
device that emits excessive electrical noise.
•
Keep the receiver's antenna at least 1cm away from conductive materials such as carbon or
metal.
•
Do not power on the receiver during the setup process to prevent loss of control.
7.1 Attentions
7.2 Binding
If you need to re-bind the receiver, please refer to [4.2 Bind] for the steps.
Notes：
1.
Set the transmitter to its binding state first, and then set the receiver to its binding state. If
the binding is not completed within 10s, the indicator light of the receiver will enter its slow
flashing state.
2.
If re-binding is successful, all the settings of the car lights will be restored to their default
values.
7.3 Firmware Update
The firmware of this receiver can be updated through the FlyskyAssistant (Only version 3.0 or
above is supported. The firmware of FlyskyAssistant is available on the Flysky official website).
1. This receiver can be updated via the following two ways: After the binding between the
transmitter and the receiver (the LED of the receiver is solid on), connect the transmitter to
the computer, then open the FlyskyAssistant on the computer to update the firmware.
2. Connect the transmitter to the computer. Then put the receiver to enter the forced update
mode by referring to the following three ways (The LED of the receiver operates in three-flash-
one-off manner repeatedly). Afterwards, open the FlyskyAssistant on the computer to update
the firmware.
• Power on the receiver while pressing and holding the BIND button for more than ten
seconds, until the LED of the receiver operates in threeflash-one-off manner repeatedly,
then release the BIND button.
