FS-G7P
Digital Proportional Radio Control System
Website
10
6.3 Settings-Neutral Trim
Function: Set and adjust the neutral data of each channel.
This function is mainly used for the trim of the model in assembly and debugging. For example,
the vehicle is stationary and the transmitter traversing handwheel is in the neutral position; if
you find that the wheels deviate from the straight direction, it can be easily corrected through
this function. At this time, it is difficult and inconvenient to adjust the model structure.
Note: Before setting this function, make sure that the channel is moving in the correct direction.
Function settings:
1.
In the SET menu, select the SUB TR(neutral trim) function and press the OK key.
2.
Select the channel you need to adjust by the pressing UP/DOWN key. Press the OK key to enter
the edit state. Then adjust it by the pressing UP/DOWN key. Press return after adjustment.
3.
Observe and test the function to ensure that the settings work as expected.
6.4 Settings-Dual Rate
Dual rate allows you to quickly adjust the output value of certain channels to achieve the best
manipulation effect. The rate function can be used to set the direction channel channel 1,
throttle channel channel 2 upper, brake channel 2 lower channel, and output data rate. The range
is 0-100%. You can also set the switch-on and switch-off. The two control modes can be switched
through the application switch setting, see the Key Setting menu.
Function settings:
1.
In the SET menu, select the D/R(Dual rate) function and press the OK key.
2.
Select the channel you need to adjust by the pressing UP/DOWN key. Press the OK key to enter
the edit state. Then adjust it by the pressing UP/DOWN key. Press return after adjustment.
In the adjustment, observe by operating the corresponding channel handwheel and throttle
trigger.
3.
Verify the function to confirm that all channel outputs operate normally as expected.
corresponding structure for the best match, to obtain the required operation effect. For example:
You want to operate that the turning action is not so large, you can adjust the value of the
direction channel at both ends to be smaller. In this way, the turning action should be smaller,
with less likely to be tailspin.
Function settings:
1.
In the SET menu, select the EPA(servo travel) function and press the OK key.
2.
Select the channel you need to adjust by the pressing UP/DOWN key. Press the OK key to enter
the edit state. Then adjust it by the pressing UP/DOWN key. Press return after adjustment.
3.
Test the function to confirm all the servo or motor action directions are the same as the
actual expected travels.
