1. Start at the edge of the lawn nearest to the power
point so the cable is laid out on the lawn you have
already cut. (N)
2. Cut your grass twice a week during the growing
season, your lawn will suffer if more than a third of
its length is cut at one time.
Do Not Overload Your Product
Using in long thick grass may cause the motor speed to
drop, you will hear a change in the motor sound. If the
motor speed drops you may overload your product
which may cause damage. When using in long thick
grass a first cut with the cutting height set higher will
help reduce the load. See Adjusting the Cutting Height.
How to Use
N
• Always handle the plastic cutters with care - sharp
edges could cause injury. USE GLOVES.
Checking your Cutting System (R)
• The cutting system must be kept in good condition
and inspected before and after use.
• Disconnect from the mains electricity supply and wait
until the cutting head has stopped rotating. Turn your
product upside down.
1. Visually check cutting head for wear. Replace if damaged.
2. Visually check plastic cutters for wear and replace
when necessary.
3. Plastic cutters should be straight. Replace if bent or
twisted.
Replacing Plastic cutters (S)
• Use only genuine Flymo replacement plastic cutters
specified for this product. These are available from
all Husqvarna UK Ltd. Service Centres and major
retail outlets.
• Plastic cutters must be replaced in pairs to retain balance.
• Two plastic cutters of the same type should be fitted.
• Never fit a metal bar blade to this product.
To Replace Plastic Cutters
• Disconnect from the mains electricity supply and wait
until the cutting head has stopped rotating. Turn your
product upside down.
1. Push plastic cutter towards centre of cutting disc. Lift
plastic cutter away from cutting head. (T)
2. If the plastic cutter is broken during use - lever cutter
out of the slot, and dispose of carefully.
3. Fit new plastic cutters into the slots at each side of
the cutting head and pull into place. (V)
• IMPORTANT ENSURE PLASTIC CUTTERS ARE
CORRECTLY LOCATED.
R
S
V
T
cutting
head
plastic
cutters
hood
fan
Cutting System Maintenance
