Use
1. Use the trimmer only in daylight or good artificial light.
2. Avoid operating your trimmer in wet grass, where
feasible.
3. Take care in wet grass, you may lose your footing.
4. On slopes, be extra careful of your footing and
wear non-slip footwear.
5. Do not walk backwards when trimming, you could
trip. Walk, never run.
6. Switch off before pushing the trimmer over
surfaces other than grass.
7. Never operate the trimmer with damaged guards
or without guards in place.
8. Never fit metal cutting elements.
9. Keep hands and feet away from the cutting means at all
times and especially when switching on the motor.
10. Keep cutting head below waist level.
11. Do not lean over the trimmer guard whilst trimming or
edging - objects may be thrown by the cutting line.
12. Beware of cut-off pieces of nylon line ejected
during use.
13. If you hit an object, do not use your trimmer until
you are sure that the entire trimmer is in a safe
operating condition.
14. If the trimmer starts to vibrate abnormally, check
immediately. Excessive vibration can cause injury.
Maintenance and storage
1. Keep all nuts, bolts and screws tight to be sure
the trimmer is in safe working condition.
2. Replace worn or damaged parts for safety.
3. Only use the replacement cutting line specified
for this product.
4. Only use replacement parts and accessories
recommended by Husqvarna UK Ltd..
5. To avoid the risk of injury keep fingers and hands
clear of the line cutter on the leading edge of the
guard.
6. Clean unit with a dry cloth. Never use metal
objects to clean the unit.
7. Inspect and maintain the trimmer regularly. Any repairs
must be carried out by an authorised repairer.
8. Store in a cool dry place and out of reach of
children. Do not store outdoors.
9. Allow the product to cool for atleast 30 minutes
before storing.
Assembly Instructions
Safety Guard Assembly (A) & (B)
1. Locate the safety guard (B1) over the cutting head
(A2). Ensure the nylon line is fed through the hole in
the safety guard as illustrated in fig A.
2. Push into location and turn safety guard in the direc-
tion illustrated in Fig B, until a click is heard and the
safety guard is securely locked in position.
• ENSURE THE SAFETY GUARD IS SECURELY IN
PLACE BY ATTEMPTING TO TWIST GUARD.
Wheel Assembly (C) & (D)
1. Fix the 2 halves of the wheel together as illustrated
in fig C.
2. Attach the wheel to the trimmer making sure that it is lo-
cated into the groove on the trimmer head (D1).
3. Clip the wheel together on the other side, making
sure it is secure.
4. The wheel should turn freely.
B
A
C
D
1
2
1
Attatching the Trimmer Head to the Sabre Handle
1.
Push the Trimmer Head onto the Sabre Handle until you hear a click. (E1)
2.
Push the Trimmer Head further onto the Sabre Handle until it reaches the mark shown in Fig E2.
3.
Turn the Trimmer Head collar until it is secure. (E3)
E2
E1
E3
