Assembly Instructions con’t
Auto Line Feed System
To adjust the Sabre handle length
1.
Loosen the Sabre Handle collar. (G1)
2.
Adjust length of the handle to the most comfort-
able operating position (G2).
3.
Re-tighten the Sabre Handle collar.
G2
G1
Sabre Handle Length Adjustment
H
line cutter
How the automatic line feed works (H)
1. When initially switching on the trimmer, a small
length of line is fed out.
2. A ‘clattering’ noise will be heard when the nylon line
hits the line cutter. DO NOT BE ALARMED this is quite
normal. After approximately 5 seconds the line will be
cut to the correct length and the noise will reduce as
the motor reaches full speed.
• Make sure the motor is up to full speed before trim-
ming or edging.
3. If the noise of the nylon line being cut cannot be
heard, more line will need to be fed out.
4. To feed more line, it is first necessary to to allow the
motor to stop completely, then re-start, allowing the
motor to reach full speed.
5. Repeat step 4. until you hear the line hitting against the
cutter. (Do not repeat this procedure more than 6 times)
6. If problems are experienced with the automatic line
feed refer to Fault Finding Chart.
F1
F2
F3
Fitting the Steady Handle
1. Squeeze the lever on the steady handle (F1)
2. Attach the steady handle to product by releasing the lever and letting the handle latches fix into the slots on
the Sabre Handle.(F2)
3. Removal is the reverse procedure.
Adjusting the Steady Handle
1. Adjust the steady handle to a comfortable operating position by squeezing the lever and moving the handle
up and down the Sabre Handle (F3)
