TROUBLESHOOTING
a
WARNING: Always stop the power tool and disconnect the power cord before performing any of the
recommended remedies below.
Trouble
Cause
Remedy
The motor fails to start when the
trigger is squeezed.
1. Battery pack is not secure.
2. Battery pack is not charged.
1. Make sure the battery pack is fully
secured in the power tool.
2. Charge the battery pack.
The power tool will not start.
1. Attachment not correctly
assembled in the powerhead.
2. Battery pack is not secure.
3. Battery pack is not charged.
4. Defective power switch.
1. Assemble the attachment correctly in
the powerhead.
2. Make sure the battery pack is fully
secured in the power tool.
3. Charge the battery pack.
4. Call an authorized service center
Cutting blade stops under load
Cutting too fast
Cut at a slower pace.
Fails to stop when one switch lever
is released.
Internal wiring defective
Call an authorized service center
Poor cut quality
1. Debris caught in blades
2. Damaged blades
1. Clear debris from blades
2. Call an authorized service center
TECHNICAL DATA
unit
C-Li 20VHT
Motor specifi cations
Motor type
Brushed
Motor voltage
V (DC)
20
Motor power
W
270
Noise and vibration data
Equivalent vibration level (ahv, eq) front handle. See Note 1.
m/s
2
1.8
Equivalent vibration level (ahv, eq) rear handle. See Note 1.
m/s
2
1.1
Sound power level, guaranteed (LWA). See Note 2.
dB(A)
98
Sound power level, measured. See Note 2.
dB(A)
95.3
Sound pressure level at operator’s ear. See Note 3.
dB(A)
85.8
Blade specifi cations
Blade speed
min
1
1200-1350
Blade length
cm (in)
40.6 (16)
Cutting capacity
mm (in)
12.7 (0.5)
Product mass
Weight (without battery pack)
kg (lb)
2.53 (5.58)
Weight (with battery pack)
kg (lb)
2.92 (6.43)
Note 1:
Reported data for equivalent vibration level has a typical statistical dispersion (standard deviation) of 1.5 m/s
2
.
Note 2:
Noise emissions in the environment measured as sound power (LWA) in conformity with EC directive 2000/14/
EC. Reported sound power level for the machine has been measured with the original cutting attachment that gives
the highest level. The difference between guaranteed and measured sound power is that the guaranteed sound power
also includes dispersion in the measurement result and the variations between different machines of the same model
according to Directive 2000/14/EC.
Note 3:
Reported data for equivalent sound pressure level for the machine has a typical statistical dispersion (standard
deviation) of 3 dB(A).
9
