3
21. Connect the wire connectors between the actuator and har-
ness. Use the zip ties in the kit to secure the wires to the
bagger frame.
17. Install the lower bracket assembly onto the bagger support
frame and align the mounting hole with the current hole in
the frame. Install the 2 1/2” carriage bolt from the kit through
the mounting hole, making sure to have the threaded end
of the bolt facing towards the center line of the tractor. The
support bracket that extends from the back plate should be
installed between the frame and lower bracket assembly.
18. Using a 9/16” socket, install a lock nut and washer provided
in the kit on the 2 1/2” carriage bolt and tighten down.
19. Using the 2-3/8” clevis pin, install the actuator onto the lower
bracket assembly with the motor facing towards the front of
the tractor.
20. Push a clip through the hole on the end of the 2-3/8" clevis pin.
ASSEMBLY INSTRUCTIONS FOR TRACTORS
FACTORY EQUIPPED WITH ELECTRIC DUMP
SYSTEM BEGIN HERE.
16. Using a 9/16” wrench and 9/16” socket, remove the bolt and
nut that holds the bagger assembly support bracket to the
bagger support frame.
15. Remove the bolts holding the adjustment bracket to the
support tube and then remove the pivot bracket from the
adjustment bracket. Replace the adjustment bracket (A) with
the high strength version included in the kit. Complete this
step on both sides of the tractor.
NOTE: This may require adjustment of the bagger. Please
refer to the tractor Owner’s/Operator's Manual for adjustment
procedures.
A
22. Pass the harness through the switch opening and then attach
the new battery cover.
23. Plug the harness into the switch.
24. Snap the switch into the battery cover.
