SETUP AND USE
6
Setup and use
1. Take the flying tent out of the packaging and the pack sack.
2. Check whether the delivery is complete (
Fig.
A
) and whether the flying tent or individual parts
exhibit damages. If this is the case, do not use the flying tent. Contact the manufacturer at the
specified service address.
Setup as a hammock tent
B
2
C1
C2
15
21
4
D
1. Take the flying tent
1
out of the pack sack
7
.
2. Undo the safety strap
2
.
3. Fasten the tree slings
2
to two trees across from one another by wrapping the tree sling
around the tree trunk and pulling the end through the loop (
Fig.
B
). Repeat this process
with a second tree.
The trees should be at least 3.5
m and no more than 5
m apart.
4. Open the three tent floor clips
12
that connect the ends of the tent poles
8
and connect
the tent floor clips with the outer tent clips
16
.
−
If the prefitted quick release unit has been disassembled, hook the front loops on the quick
release unit into the carabiner clips
4
on the tent floor
13
(
Fig.
C2
).
5. Secure the tree strap by running it through the clasp
17
on the quick release unit (
Fig.
D
).
6. Hook the outer tent clasp
15
into the rear loop
21
on the quick release unit (
Fig.
C1)
.
7. Connect the other end of the quick release unit with the tree sling (
Fig.
D
).
8. Set the length of both quick release units so that the hammock tent is tensioned (
Fig.
E
).
E
