Flying Phantom Essentiel, Assembly Instructions Manual

Page: 19 / 40

19
5. Install the mast foot. Make sure there is some navy grease. Install diamond tensioner screw in
the mast foot and then in the diamond bronze.
6. Screw back the mast foot, starting with the screws on either side of the mast.
7. Put the cables on the spreaders and tighten screw.
8. Make sure the mast is straight. If not, adjust using the threaded stem of the diamond cable by
repeating the former procedure.
9. Tighten the threaded stem until pre-arching the mast (approximately 350 Kg of tension in the
cables).
10. Check that the spreaders are perpendicular to the mast.
11. Wrap the ligation of spreader M2601 around the cable.
MAST