2.
installation
Prepare
cytrynka PDB comes completely soldered and you don't need to solder nothing out of
wires for battery, ESC, FPV (OSD including). Also, if you have not ordered CB for CC3D
with wires you need to solder it.
Installation
We recommending to use spacers between bottom plate and our PDB to get best
ventilation.
If you use minimOSD is recommended to solder it on beginning. PDB is prepared to
use minimOSD without soldered pins. If you have minim like this on photo you must
remove all pins. Components must be on top. If not minimOSD tie VIN and VOUT pins
on minim video in/out connectors.
Install battery leads with proper gauge for the amount of current you plan on running.
Check two times polarity of battery connectors and pads on PDB. When soldering
ESC's wires to PDB also pay attention with polarity.
Install frame spacer (for top plate). Remember to use nylon screws (attached in
package with cytrynka PDB).
Now you can connect PDB with arms and main bottom plate (our PDB replace top
bottom plate).
5
