14
differ.
5. Position the blade in its location and tighten the nuts.
6. Replace the board covering the blade.
7. Replace the discharge screen.
8. Close the outlet of the discharge.
IX.
IX.
IX.
IX. Adjusting
Adjusting
Adjusting
Adjusting the
the
the
the belt.
belt.
belt.
belt.
There is a “V” belt under the belt guard transmitting energy from the engine to the
blade tray. The belt will be getting loose and skid after use for some time. So tension
adjustment is required.
1. Turn off the engine and remove the belt cover.
2. Loosen the four location nuts on the engine.
3. Move engine forward until the “V” belt is tight.
4. Put the main pulley and affiliated pulley in the same plane. (A ruler can be used
to measure if lack of experience). Tighten the four location holes on the engine.
5. Set the belt cover back to its place.
X.
X.
X.
X. Replace
Replace
Replace
Replace the
the
the
the belt
belt
belt
belt
The “V” belt needs to be replaced if it is too long or damaged.
1. Turn off the engine and remove the belt cover.
2. Remove the old belt. Pull the belt outside by tools and turn the pulley gradually to
remove the pulley.
Note: please mind your finger.
3. Place the new belt in the main pulley first (“V” belt on engine) and then to the
