H1 user manual
Flight safety notice
Flywing suggests that users enjoy flying in a reasonable safe environment. The knowledge of flight safety is very
important for the safety of yourself, the surrounding people and the environment.
1. Fly in open areas away from buildings, trees,high voltage power cable lines,crowd,water surface,and any near
by obstacle.
2. Please keep the transmitter in hand, even when using the auto flight /auto landing and auto home function,to
control the helicopter any time.
3. Please operate the helicopter within your sight range at all the times.
4. To ensure flight safety,please do not fly the helicopter beyond 120 meters above the ground. If there are no
flying height restriction or if the restriction is lower than 120 meters in your area, please follow the regulations.
Please visit http://www.flywingrc.com Watch flight safety teaching videos and acquire more comprehensive
safety knowledge such as flight restrictions
Pre-flight safety inspection
Please check the helicopter carefully before taking off. Precautions are as follows:
1. Check whether the main blades ,tail blades, helicopter body and landing skids are damaged or distorted, please
replace them with the genuine Fly Wing RC parts.
2. Check whether the flight control linkages and fuselage are fixed firmly, and whether the GPS unit is correctly fixed on
the helicopter tail boom (horizontally placed, straight line behind the main mast ) H1 Unit is fixed firmly on the double
sided foam pad either at the front or at the back of the main mast. Pay attention to the direction of the arrow which has
to be pointedtowards the direction of travel
3. Check whether the power of the helicopter and the transmitter are sufficient. After the transmitter is powered on, turn
on the power supply of the helicopter, and check whether the helicopter passes the self inspection test (the rotor head
and swash plate move regularly for several seconds)
Flight operation requirements
1.Do not fly in bad weather, such as strong wind (10m / s), rain, snow and foggy weather, etc.
2.Choose an open place with no tall buildings around the flight pathway. Any large number of buildings using
steel bars will affect the effectiveness of compass function , and they will block GPS signal, resulting in poor
positioning of helicopter and even unable to receive the signals.
3.Please do not fly in any area with high voltage cable line, radio tele-communication station, mobile phone
transmission tower or Wi-Fi, to avoid signal interference of your transmitter and receiver.
4.Please take extra caution when flying above 6000 meters as performance of the battery and the motor power
system of the helicopter will be reduced to cold temperature and thinner air density.
Flight operation requirements
1.Fly within your sight of range(VLOS)
2.Keep away from rotating blades and motor.
3.Activating the stop switch during flight will cause the helicopter to fall. Please use this function only in case of
emergency.
4.During the flight, please do not answer or make phone calls, send short messages or use other mobile devices
that may interfere with your helicopter operation.
5.Do not operate the helicopter under the influence of alcohol or drugs.
6.Please return home as soon as possible when low power warning appears from the transmitter.
7.In the process of runaway return, when the radio signal becomes normal again, the helicopter landing
position can be controlled by the transmitter.
8.After landing, the helicopter electronic power should be stopped first and then the transmitter should be
turned off to avoid any loss of transmitter signal.
9.When using the GPS Autopilot flight mode and Return Home functions, you should always be prepared
