Fly Sky FS-i6S, User Manual, Page: 11 / 32

7
4.
Operation Instructions
After setting up, follow the instructions below to operate the system.
4.1 Power On
Follow the steps below to turn on the system:
1. Check the system and make sure that:
• The batteries are charged and installed properly.
• The receiver is off and correctly installed.
2. Hold the power buttons until screen lights up.
3. Connect the receiver power supply to the
B/VCC port on the receiver.
Note • Operate with caution in order to avoid damage or injury.
Note
• Make sure that the throttle is at its lowest position and the switches are set to their
up position.
4.2 Binding
The transmitter and receiver have been pre-bound before delivery.
1. Turn the transmitter on, press to select
[System] , and scroll down and then select
[ RX bind ].
2. Connect the bind cable to the B/VCC port
of the receiver.
If you are using another transmitter or receiver, follow the steps below to bind the transmitter and receiver:
4.3 Pre-use Check
Before operation, perform the following steps to check the system:
1. Check to make sure that all servos and motors are working as expected.
2. Check operating distance: one person holds the transmitter, and another one moves the model away from
the transmitter. Check the model and mark the distance from where the model starts to lose control.
Danger • Stop operation if any abnormal activity is observed.
Danger • Make sure the model does not go out of range.
Attention • Sources of interference may affect signal quality.
RF standard Receiver type
AFHDS 2 iA10B,iA6B,iA6,iA4B,A6,A3
2.4G AFHDS 2A X6B,A8S
3. Connect the power to any other port. The indicator
will start to flash, indicating that the receiver is in bind
mode.
• After successfully binding the transmitter will
automatically exit this menu, then the receivers LED
will stop flashing indicating that binding has been
successful.
4. Remove the bind and power cable from the receiver.
Then connect the power cable to the B/VCC port.
5. Check the servos' operation. If anything does not work
as expected, restart this procedure from the beginning.