Flux FBM 4000 Ex, Original Attachment, Page: 14 / 28

___
14 / 28 Attachment Brushless motor FBM 4000 Ex
ENGLI
SH
5 Operating Motor
Normal operation:
In normal operation, the motor is started by pushing the switch knob.
Pushing the switch knob again will stop the motor.
Remote-controlled operation:
The switch knob is held in the "ON" position with the locking device provided with the motor.
Fig. 2: Remote-controlled operation of the FBM 4000 Ex with locking device
Position Designation
1 Switch knob set to "ON" position
2 Locking device
3 Push forward until locked into place
Attention!
In remote-controlled operation, the motor will start automatically after
a power failure!
Possible malfunctions
State of motor Reason
Repair in normal
operation Repair in remote
controlled operation
Motor goes out
or stands
Voltage interruption
(power failure, plug
was pulled)
After voltage return
and stop of the shaft,
switch on the motor
again
After voltage return the
motor starts automatically
after 5 seconds.
If the shaft already stands
at voltage return, the mo-
tor starts immediately.
Motor stands
due to overload
The temperature
monitoring stopped
the motor
After a cool-down of
approx. 6 min. the
motor can be
switched on again
After a cool-down of
approx. 6 min. and a volt-
age interruption of approx.
20 sec. (power or appli-
ance switch) the motor
can be switched on again
Motor stands
due to overload
The speed monitor-
ing stopped the
motor After approx. 20 sec.
the motor can be
switched on again
After a voltage interrup-
tion of approx. 20 sec.
(power or appliance
switch) the motor can
be switched on again
In general: If an attempt is made within these 20 seconds, the waiting time will be
increased by another 20 seconds.
1
2
3