Flux F 550 GS Series, Original Main Operating Instructions

Page: 50 / 116

50/116 Original Operating Instructions High Viscosity Liquid Pump F 550 and Sanitary Pump F 560
EE
NGLI
SH
The electrically conductive base ground must be an integral part of the equipotential
bonding system.
If a conductive base ground is not available, equipotential bonding conductors must be
connected to all barrels and containers.
Note
Explosion protection at the connection point is not necessary if the
power socket or the terminal box is clearly located outside the haz-
ardous area.
4.3 Commissioning of version with planetary gear F 550 GS and F 560 GS
Available drive motors:
x
Commutator motors FEM 4070, F 457, F 457 EL, F 458, F 458 EL,
F 458-1, F 460 Ex, F 460 Ex EL, F 460-1 Ex
x
Brushless motor FBM 4000 Ex
x
Compressed air motors F 416 Ex, F 416-1 Ex, F 416-2 Ex
x
Three-phase motor F 403
> Put the motor onto the pump.
> Firmly tighten union nut by hand.
> Insert the plug or connect the air supply hose.
> Switch
on the motor.
4.4 Commissioning of version with bearing flange F 550 S and F 560 S
Available drive motors:
x
Three-phase motors 0.75 to 1.1 kW, 700 or 930 rpm
x
Compressed air motors FPM 4 Ex, FPM 6 Ex, FPM 8 Ex,
maximum speed 1000 rpm.
Attention!
x
Installation, maintenance and repairs to three-phase motors
should only be carried out by suitably qualified personnel.
x
Only use three-phase motors with a starter including an overload cut-out switch.
x
Make sure that the supply voltage corresponds to the voltage indicated on the name
plate.
When using compressed air motors please do not exceed the maximum operating
pressure of 6 bars and use filter-regulator-lubricator unit.
x
Check direction of rotation of the motor. In case of portable use, check the conformi-
ty of phases at each socket to guarantee always the same direction of rotation.
(Direction of rotation according to the arrow on the bearing flange).
x
Clean bearing flange and motor flange. Fit the motor onto the bearing flange and
tighten the screws.