Voltage Quality Recorder
Using the Recorder
7
3.
Click on
(
VR1710 Settings
)
.
From the Settings screen, you can specify the recording interval, dip and swell
thresholds for triggering Events, or erase the Recorder’s memory.
4.
Enter the desired settings and press
Apply
. If
Apply
is not pressed, the Recorder
reverts to its previous settings.
Note
Each time that
Settings
is opened, recording data stops and will not
restart until the Recorder is plugged in again.
The percentage of recording memory used is displayed. An estimate of recording
time is shown under
Typical Continuous Measurement
. This shows the total
amount of time the Recorder can collect data. If transients are detected, the
strored waveforms will shorten the maximum recording time.
fbx003.bmp
Figure 3. Settings
Notes
When choosing recording intervals, note that shorter recording
intervals may mean a shorter period of data is taken before the
Recorder storage is exhausted, but shorter recording periods result in
richer data than if longer periods are used.
5.
Once the settings are correct, click
Apply
.