Fluke VIB 5.310, User Manual, Page: 94 / 173

3-43
Automatic data acquisition
• Connect the VIBXPERT to the multiplexer (see previous section).
• Connect an RPM sensor to the VIBXPERT, if necessary.
• In the route setup (measurement), select the option ‘Autostart
MUX’ (see p 2-16).
• Open the route* with the multiplexer measurement locations.
• Click the first measurement location on the first multiplexer in
the string linen. Note the label of the measurement locations:
• VIBXPERT starts the first measurement task at the first
measurement location and saves the result. This procedure
continues automatically until the last measurement task in
the string line. If a measurement task is already completed,
the procedure stops there. You can conduct the respective
measurement again or skip it in order to continue the data
acquisition.
Manual data acquisition
• In the route setup (measurement), deactivate the option
‘Autostart MUX’.
The measurement locations can be processed in any order. Start
the measurements at each measurement location by pressing the
button. The remainder of the procedure is the same as for automatic
data acquisition.
If the connection to the multiplexer is accidentally interrupted dur-
ing the measurement or between measurements, click ‘Reset MUX’
in the menu so that VIBXPERT can again correctly address the mea-
surement locations.
Meas. location
Multiplexer
String line (Multiplexer group)
Location name in
OMNITREND
Left:
Route contains measurement
locations on two multiplexers
Right:
Reset multiplexer
* for machine templates, the procedure
on page 3-13 applies accordingly.
Multiplexer

Note