Fluke RUSKA 7050, User Manual

Page: 35 / 88

Local Operation
Tutorial
4
4-3
Tutorial
To begin the tutorial, first verify that the PPI is powered-up and that the pneumatic
connections have been completed. The PPI should display a screen similar to the one
shown below. (The right hand side of the display should show the options). At power up,
there may be errors relating to the default settings. If an error message is displayed in red
at the bottom of the screen, press [F6], then press PREVIOUS. If multiple errors exist,
you will need to press the [F6] key multiple times to clear all of the errors.
4-3.bmp
Figure 4-3. Main Menu
Figure 4-3 shows the Main Menu. It is at the top level of the menu tree (see Figure 4-2)
and all descriptions in this manual start from this point. The double sized numbers in the
top center of the display shows the current measured pressure. The upper left corner
shows the current mode of the PPI. The right side of the screen shows a bar graph
displaying the current pressure relative to a user-configurable full-scale value. The
highlighted label on the right hand side of the screen displays the current assignments of
the function keys [F1] through [F6] that are located beside the display.
1.
Change the pressure units. The units are changed by selecting the UNITS key on the
keypad.
glc11.bmp & glc12.bmp
Figure 4-4. Units Menu