Fluke P3100 Series, User Manual

Page: 46 / 58

P3100 & P3200 Series
Users Manual
6-14
Table 6-5. Priming Pump Assembly - Parts List
Item Description Part Item Description Part
1 Pivot Clip 3920224 8 Rambler 3919165
2 Clevis 3920236 9 Back-Up Ring 3920516
3 Locknut 3918713 10 O Ring 3864782
4 Pump Union Nut 3921527 11 Barrel Locknut 3921438
5 Shaft Bearing 3867744 12 Pump Barrel 3921511
6 Pump Shaft 3921509 13 O Ring 3864711
7 Ball 3917855 14 Pump Block Assembly
Check Valves
Inlet Check Valve
The inlet check valve is a bought-in item, and is not readily user-serviceable. To remove:
1. Disconnect nylon tubing from connector (9), by pressing in the collar at the top of the
connector, and gently pulling on the tubing.
2. Unscrew and remove connector.
3. Remove check valve assembly (8).
4. When replacing the check valve assembly, take care to remove all traces of PTFE or
Teflon sealing tape on the mating threads of elbow (7). New tape (or similar sealing
method) must be applied to ensure a pressure-tight joint.
5. Reassembly is the reverse of removal.
Outlet Check Valve
1. Remove screws (7) and pump check flange (6), taking care not to drop the check
valve bullet (3) and spring (4).
2. Inspect the parts for cleanliness and damage—particularly the sealing surfaces.
3. When removing O-rings, take care not to use any tool that may have a sharp edge that
will scratch the surfaces of the mating groove, otherwise it may leak when
reassembled.
4. Reassembly is the reverse of removal, but care mast be taken to ensure that the spring
and bullet are seated correctly.