Workgroup Analyzer
Using the Analyzer
21
Root mode user commands:
“management”
Allows the user to enter “Management” configuration mode.
This mode allows the user to configure IP parameters for the
out-of-band Management port. The text “/Management>” is
appended to the prompt while in this mode.
“network”
Allows the user to enter “Network” configuration mode. This
mode allows the user to configure IP parameters for the in-
band Network-Under-Test (NUT) port. The text “/Network>”
is appended to the prompt while in this mode.
“default”
Restores the analyzer configuration parameters back to factory
defaults and reboots the analyzer. Password settings are
retained.
“password”
Set remote access password (one password for all interfaces).
The user is prompted for a password, then again for
confirmation. Upon entering a password, password protection
will be enabled. If no password is entered, password
protection will be disabled. The password is case sensitive, is
restricted to 40 characters, and any printable ASCII character
can be used (including spaces). If you forget the password,
you will need to contact your authorized service center or
Fluke Networks product support for procedures. See page 2
for phone numbers.
“remoteipaddr
A.B.C.D”
Set the IP address (A.B.C.D) of the PC that will be running
the user interface software. The analyzer will then send it’s
identification to that PC so that the OptiView Browser will
display that analyzer for selection. Address is entered in
decimal dot notation. See help for more information about
setting the Remote PC IP address.
“inspectoripaddr
A.B.C.D”
Set the IP address (A.B.C.D) of the PC that will be running
the OptiView Inspector Console software. The analyzer will
then send it’s identification to that PC so that the console
software can use the analyzer as a data source, receive the
problem log from the analyzer and display the analyzer within
the “Fluke Tools” device discovery tab.
“exit”
Exits the Root mode if password protection is enabled. The
user must enter the correct password to regain configuration
access.
“show (user
command)”
Displays the current value of an individual setup parameter of
interest within the Root mode.
“show all”
Displays the current values of all setup parameters within the
Root mode.
