Monitoring Optical Power
41
Monitoring Optical Power
1
Clean the tester’s input port and the reference test cord
and source connectors.
2
Use the reference test cord to connect the source to the
tester’s input port, as shown in Figure 19. Turn on the
source.
3
Turn the rotary switch to
MONITOR
. If the media type is
not set to
Fiber
, press
J
Change Media
to change it.
4
Select
Power Meter
. You do not need to select a fiber
type or test limit.
5
Select the correct wavelength; then press
P
.
To change the wavelength after starting the test, press
L
Change
λ
.
Summary of Contents for DTX-GFM2
