Fluke DSP-FOM Service Information Sheet Download Page 1

PN 616141
September 1996, Rev. 2, 1/02

1996-2002 Fluke Networks, Inc. All rights reserved. Printed in USA. Product names are trademarks of their respective companies.

DSP-FOM

Fiber Optic Meter

Service Information Sheet for Serial Numbers < 79370000

Introduction

This Service Information Sheet provides the
following service information for the DSP Fiber
Optic Meter (hereafter referred to as the FOM) with
serial numbers < 79370000.

 

Parts and warranty service information

 

Specifications

 

Theory of operation

 

Cleaning procedures

 

Required equipment

 

Performance tests

 

Procedures for disassembling and
reassembling the FOM

 

Calibration adjustments

 

Parts and accessories lists

 

Schematic

 

Diagram showing calibration measurement
and adjustment points

For operating instructions, refer to the
DSP-FOM/DSP-FTK Fiber Optic Accessory
Instruction Sheet
.

Parts and Warranty Service

The FOM is warranted to be free from defects in
material and workmanship for one year, while
under normal use. Parts and repairs are warranted
for 90 days.

Refer to the Instruction Sheet for the complete
warranty statement.

To order parts, or for warranty service, contact
Fluke as follows:

U.S.A.: 1-888-993-5853

Canada: 1-800-363-5853

Europe: +31-402-675-200

Japan: +81-3-3434-0181

Singapore: +65-738-5655

Anywhere in the world: +1-425-446-4519

For operating assistance in the USA, call
1-800-283-5853.

Visit the Fluke Networks web site at

www.flukenetworks.com

.

Fluke DSP-FOM Specs

Provided by www.AAATesters.com

Summary of Contents for DSP-FOM









Reviews: