PN 4784850
September 2016
© 2016 Fluke Corporation, All rights reserved. Specifications are subject to change without notice. All product names are trademarks of their respective
companies.
700HPPK
High Pressure Pneumatic Test Pump
Instructions
Introduction
The Fluke 700HPP High Pressure Pneumatic Test Pump
(the Product) is a portable device that produces precise
pressures up to 21 MPa (3000 psi). The 700HPPK (the
Kit) includes the Product and a High Pressure Calibration
Manifold (HPM) with hose.
Contact Fluke Calibration
To contact Fluke Calibration, call one of the following
telephone numbers:
•
Technical Support USA: 1-877-355-3225
•
Calibration/Repair USA: 1-877-355-3225
•
Canada: 1-800-36-FLUKE (1-800-363-5853)
•
Europe:
+31-40-2675-200
•
Japan:
+81-3-6714-3114
•
Singapore:
+65-6799-5566
•
China:
+86-400-810-3435
•
Brazil:
+55-11-3759-7600
•
Anywhere in the world: +1-425-446-6110
To see product information or download manuals and the
latest manual supplements, visit Fluke Calibration’s
website at
www.flukecal.com.
To register your product, visit
http://flukecal.com/register-
product.
Safety Information
A
Warning
identifies conditions and procedures that are
dangerous to the user. A
Caution
identifies conditions and
procedures that can cause damage to the Product or the
equipment under test.
Warning
To prevent personal injury:
•
Read all safety information before you use
the Product.
•
Use the Product only as specified, or the
protection supplied by the Product can be
compromised.
•
Carefully read all instructions.
•
Do not use the Product if it operates
incorrectly.
•
Do not use the Product if it is altered or
damaged.
•
Disable the Product if it is damaged.
•
Do not attempt to operate the Product above
its rated pressure.
•
Avoid tipping the Product so that it will fall
over.
•
Use care when working with this Product. Do
not drop the Product or strike it with sharp
objects.
•
Carefully follow the cleaning and
decontamination instructions in the manual.
Do not use unapproved solvents or cleaners
on the product.
Symbols
The symbols shown in Table 1 are found in these
instructions or on the Product.
Table 1. Symbols
Symbol Definition
WARNING.RISK OF DANGER.
Consult user documentation.
Certified by CSA Group to North American safety
standards.
Conforms to European Union directives.
Conforms to relevant Australian Safety and EMC
standards.
This product complies with the WEEE Directive
marking requirements. The affixed label indicates
that you must not discard this electrical/electronic
product in domestic household waste. Product
Category: With reference to the equipment types in
the WEEE Directive Annex I, this product is classed
as category 9 "Monitoring and Control
Instrumentation" product. Do not dispose of this
product as unsorted municipal waste.
