635/633 Users
Manual Supplement
12/01
11
3.
To change the default user pattern, do the following:
a) Press the RESULTS
key to select “0” or “1” for the
bit in the first position.
Notes
To clear all of the bits in the current length of
the pattern and set them all to “1”, press and
hold the RESULTS
key for approximately
two seconds. To set all of the bits to “0”,
press and hold the RESULTS
key.
To erase all of the bits and start with a
pattern length of one bit that is set to “0”,
press the SIGNALING TYPE (Reset) key.
b) Press the LOOP CODE
(
→
) key to move right to the
next position. Then, press the RESULTS
key to
select “0” or “1” for the bit.
Continue in this manner until you have specified the
entire user pattern.
Notes
To move among the bits, press the LOOP
CODE
(
→
) key to scroll right and
the LOOP CODE
(
←
) key to scroll
left.
To delete the last character in the pattern,
select it. Then, press the RESULTS
key.
4.
When the desired user pattern is displayed, press the
TXCLK SOURCE (Done) key.
You return to the first page of the setup menu. “User
Pattern” is blinking.
5.
Press the MODE (Done) key to exit the setup menu.
