Manual Supplement
635/633 Users
10
12/01
Section 2-37, add the following to the end of the paragraph:
To loop up the second doubler (if provided) from the customer
side, select the CDU2 loop code and press the SEND LOOP UP
key. To loop down the second doubler, select the CDU2 loop
code and press the SEND LOOP DOWN key.
On page 2-20, section 2-54, replace the entire procedure in the
second paragraph with the following:
1.
Press the MODE key
until this screen is displayed:
User Pattern
Done
Setup
Contrast
abn22f.eps
“User Pattern” is blinking.
2.
Press the SIGNALING TYPE (Setup) key.
A screen similar to the following is displayed:
Note
On your screen, the pattern length that is
displayed may not match the one shown in the
following figure. There are 64 bits for which you
can specify a pattern.
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 0 0 0
Reset Done
abn23f.eps
The bit in the first position is blinking to indicate that it is
selected.
