Fluke 55XXA Instructions Download Page 4

Page: 4 / 4

55XXA

Instructions

6. The steps to attach the top-panel front cross bar are similar to attach the top-panel rear

cross bar. However, it is easier to attach the cover/pouch to the cross bar first. See

a. With the Fluke logo on the display cover/pouch facing you and right-side up, thread the

ends of the two top straps through the top slots at of the cross bar.

b. Loop the ends around the cross bar and secure the ends to the top of the straps with

the hook and loop fasteners.

c. Once the straps are attached to the cross bar, attach the top-panel front cross bar to

the top of the Product. Remove the screws and replace the cross bar. Make sure the

pouch straps are at the front.

Figure 4. Loop Straps Through Cross Bars

7. Turn the Product upside down.
8. Attach the bottom-panel rear cross bar to the bottom of the Product. Remove the screws

and replace the cross bar.

9. The steps to attach the bottom-panel front cross bar are similar to the steps to attach the

top-panel front cross bar. Attach the last two display cover/pouch straps to the cross bar

first. See

10. Once the straps are attached to the cross bar, make sure the cross bar slots face towards

the front of the product and attach the bottom-panel front cross bar as you attached the

top-panel front cross bar.

11. With the M4x10 screws, attach the other corner handle assembly to the other side of the

Product using the screw holes from the standard handles. Use five screws for each handle.

Use a Torx T20 driver and torque to 12.5 in-lbs.

12. Make sure that all screws are tightened.
13. Place the Product right-side up, restore the power cable, and connect to power. The

Product is ready use.

Front Cross Bar

Display Cover/Pouch Straps

Summary of Contents for 55XXA

Page 1: ...otection and add more hand holds to make the Product easier to lift The display cover pouch protects the front panel and can hold assorted test leads or other items Figure 1 55XXA Portability Kit Inst...

Page 2: ...luded Assemble the Handles Attach the 2 side handles to the 4 corner handles See Figure 2 For each pair of corner handles use a Phillips screwdriver to tighten 2 M5X10 screws torque to 12 5 in lbs and...

Page 3: ...standard handles Use five screws for each handle All 20 M4 handle screws require a Torx T20 drive Tighten to a torque of 12 5 in lbs 5 Attach the top panel rear cross bar to the Product See Figure 3...

Page 4: ...down 8 Attach the bottom panel rear cross bar to the bottom of the Product Remove the screws and replace the cross bar 9 The steps to attach the bottom panel front cross bar are similar to the steps t...