Portability Kit
Installation
3
Installation
When you install the Kit on the Product, do not remove too many screws from the Product at
once. To do so can cause the Product covers to shift and make the Product come apart.
To install the Kit on the Product, See
1. Turn off the Product and remove the mains power cord.
2. Place the Product on a flat surface.
3. Start with one side (left or right). Use a 3 mm hex wrench to remove the side front and rear
handles (each handle has 5 screws).
4. With the M4x10 screws, attach one of the handle assemblies to the Product. Use screw
holes that held the standard handles. Use five screws for each handle. All 20 M4 handle
screws require a Torx T20 drive. Tighten to a torque of 12.5 in-lbs.
5. Attach the top-panel rear cross bar to the Product. See
a. On the rear of the Product top-panel, use a Phillips screwdriver to remove the four
screws. Do not remove the screws from the top-panel front side yet.
b. With the slots of the cross bar facing out, slide one end tab of the cross bar into the
hole on the corner handle.
c. Use four M3X8 screws to attach the cross bar to the top rear of the Product. The four
cross bar screws require a Phillips bit. Torque of 8 in-lbs.
Note
Start each of these screws but wait to tighten until all are started.
Figure 3. Attach the Cross Bar to the Handle and Top of the Product
Cross Bar
Cross Bar
(4) M3X8 Screws
