1000FLT
Users Manual
6
Lamp Test
The Lamp Test verifies that the lamp is gas-filled. This test
is done with or without the lamp in the fixture. You can test
with the rod extender pulled out or collapsed.
Warning
To prevent possible electrical shock or
personal injury, do not touch the rod extender
while performing the Lamp Test.
To test (see Table 3):
1. Turn on the Product.
2. Push
for <1 second. The green light around the
button perimeter turns on and the LED test indicator
blinks green
. Product is ready to test.
3. Continue to push and hold
for the entire test
duration.
4. Place the saddle end of the Product on the lamp and
continue to hold
.
If the fluorescent lamp is good (gas-filled), the
fluorescent lamp starts to blink
.
If the fluorescent lamp is bad (no gas), the fluorescent
lamp does not blink
.
5. Release
to end the test.
Note
The Product goes to the default Pin Test mode
after 30 seconds of non-use.
Table 3. Lamp Test
huz09.eps
Item LED
Description
blinking green
Test in progress
blinking green
Good fluorescent lamp blinks
blinking green
Bad fluorescent lamp does not blink
1
2
3
