Fluorescent Light Tester
Before You Start
3
Table 1 is a list of symbols used on the Product and in this
manual.
Table 1. Symbols
Symbol Description
Important information. See manual.
Hazardous voltage
Power ON/OFF
Beeper
Battery
Conforms to relevant Australian standards.
Conforms to requirements of European Union
and European Free Trade Association.
Conforms to relevant South Korean EMC
standards.
Conforms to relevant North American Safety
Standards.
This product complies with the WEEE Directive
(2002/96/EC) marking requirements. The
affixed label indicates that you must not discard
this electrical/electronic product in domestic
household waste. Product Category: With
reference to the equipment types in the WEEE
Directive Annex I, this product is classed as
category 9 “Monitoring and Control
Instrumentation” product. Do not dispose of this
product as unsorted municipal waste. Go to
Fluke's website for recycling information.
Before You Start
The purchase of your Product includes:
•
Fluke
1000FLT
•
4 AA Batteries
•
Soft Carry Case/Holster
•
Quick Reference Guide
•
Safety
Information
Make sure that the Product shipment is complete. If not,
contact Fluke (see page 1). Install the batteries before you
operate the Product. See
Battery Replacement
for more
information about how to install.
Power On and Off
Push
<1 second to turn on and turn off the Product. The
power button has a green light around the perimeter when
on. The Pin Test is the default mode when you turn on the
Product.
The Product automatically turns off after 20 minutes of
non-use.
Battery
The Product operates on four AA Alkaline IEC LR6
batteries.
changes from green to blinking green as a
warning when the battery power is low (typically, 85 % of
capacity). The Product continues to function normally.
