Fluke Biomedical 4468525, User Manual

Page: 31 / 32

Infusion Device Analyzer
General Specifications
21
General Specifications
Battery Power ........................................................ 4 x Panasonic HHR210AB NiMh 2000 mAh batteries
Charger
Operating Voltage Range ................................... 100 V ac to 240 V ac
Supply Frequency ............................................... 50 Hz / 60 Hz
Supply Power ...................................................... <20 VA
Size (HxWxD) ......................................................... 30 cm x 17 cm x 10 cm (12 in x 8 in x 4 in)
Weight .................................................................... ~1.2 kg (2.7 lb)
Temperature
Operating ............................................................ 15
°
C to 30
°
C (59
°
F to 86
°
F)
Storage ............................................................... -20
°
C to +40
°
C (-4
°
F to +104
°
F) when drained of all liquid.
Humidity ................................................................. 10 % to 90 % non-condensing
Altitude ................................................................... 0 meters to 2000 meters (6500 feet)
Safety ..................................................................... IEC 61010-1: Overvoltage category II, Pollution Degree 2
Electromagnetic Environment ............................. IEC 61326-1: Basic
Emissions Classification ...................................... IEC CISPR 11: Group 1, Class A. (Group 1 have intentionally
generated and/or use conductively coupled radio-frequency energy
which is necessary for the internal functioning of the equipment itself.
Class A equipment is suitable for use in non-domestic locations and/or
directly connected to a low-voltage power supply network.)
FCC ......................................................................... CFR47: Class A Part 15 subpart B
Storage of Results ................................................ Test results stored for later viewing, printing or transfer to PC. Typical
practical capacity: 100 tests
Power Down .......................................................... The results of tests in progress will be saved in the case of accidental
power down
Computer Control ................................................. The Product can be fully controlled from a PC using HydroGraph
software
Performance Specifications
Average Flow Rate Measurement
Technique ........................................................... Flow is calculated by measuring volume over time
Range ................................................................. 0.5 ml/h to 1000 ml/h
Accuracy ............................................................. 1 % of reading ±1 LSD for flows of 16 ml/h to 200 ml/h for volumes
over 20 ml; otherwise 2 % of reading ±1 LSD for volumes over 10 ml
under laboratory conditions
Max test duration ................................................ 10 hours on battery
Volume Measurement
Technique ........................................................... Volume is measured directly by the measuring module in minimum
sample sizes of 60 µl
Range ................................................................. 0.06 ml to 999 ml
Accuracy ............................................................. 1 % of reading ±1 LSD for flow rates of 16 ml/h to 200 ml/h for volumes
over 20 ml. Otherwise 2 % of reading ±1 LSD for volumes over 10 ml
under laboratory conditions
Max test duration ................................................ 10 hours on battery
Pressure Measurement
Technique (Occlusion test) ................................. Direct measurement of pressure at the inlet port
Range ................................................................. 0 psi to 45 psi and equivalent in mmHg, Bar and kPa
Accuracy ............................................................. 1 % of Full Scale ±1 LSD under laboratory conditions
Max test duration ................................................ 30 minutes