FW_F133P_v1702_02_EN
Page 7
Options
The following options are available: full Modbus communication RS232/485/TTL (also battery
powered), intrinsic safety, mechanical relay or active output, power- and sensor-supply options,
panel -mount, wall-mount and weather-proof enclosures, flame proof enclosure and LED backlight.
2.
OPERATIONAL
2.1.
GENERAL
This device may only be operated by persons who are authorized and trained by the
operator of the facility. All instructions in this manual are to be observed.
Take careful notice of the "Safety rules, instructions and precautionary measures" in the
front of this manual.
This chapter describes the daily use of the F133-P . This instruction is meant for users / operators.
2.2.
CONTROL PANEL
The control panel has three keys. The available keys are:
Fig. 2: Control Panel
Functions of the keys
This key is used to program and save new values or settings.
The PROG/ENTER key is also used to gain access to the setup menu (read
chapter 3).
This key is used to START the dispense process.
The START/
key is also used to increase a value after the PROG/ENTER key has
been pressed (read chapter 3).
This key is used to pause or stop the dispense process.
The STOP/
key is also used to select the batch total, the batch counter, the total
and the accumulated total.
The STOP/
key is also used to select a digit or an option after the PROG/ENTER
key has been pressed (read chapter 3).
2.3.
OPERATOR INFORMATION AND FUNCTIONS
In general, the F133-P operates in the operator mode. The shown information depends on the
settings which are made in the setup menu.
The signal from the connected sensor is processed by the F133-P in the background, independent
from the selected display refresh rate.
Start-up the delivery
You only can start-up when the "READY" indicator is shown on the display. When "READY" is
shown, the data of the last delivery is shown. When you press the "START" key, the F133-P initiates
a new delivery, the "RUN" indicator comes on and temporarily the total shows "8888888" and the
flow rate "88888". Depending on the setup of the F133-P, relays are switched to start the pump(s)
and to open the valve(s). In the software, a timer is started to monitor the flow rate.
When a flow is detected, the delivery will start and the total and the flow rate show the actual status.
When the flow rate is not sufficient, the delivery will not start and the Alarm indicator comes on, the
total shows "0000000" and the flow rate shows "not started". The startup sequence is stopped.
Fig. 3: Process information (typical)
Fig. 4: Delivery information (typical)
RUN
RUN
