User Manual
E115-P
Page 56
FW_E115-P_M_v0301-01_EN
COMMUNICATION
Function
Reading display information, reading/writing all configuration settings, and data log extraction
Type CB
Modbus ASCII/RTU - RS232
Type CH
Modbus ASCII/RTU - RS485 2-wire, bus termination without resistor for low power solutions
Type CU
USB communication incl. Ex d plug (requires ¾”NPT or M25 side entry thread)
Type CX
No communication, remote configuration possible with accessory cable (ACE02)
Speed (baud)
1200 - 2400 - 4800 - 9600 - 9600HP - 19200 – 38400
Addressing
Maximum 247 addresses
A.4
OPERATIONAL
OPERATOR FUNCTIONS
Displayed information
●
Differential total and/or flowrate
●
Differential total and non-resettable accumulated total
●
Total A forward flow
●
Total B reverse flow
●
Speedometer flowrate: differential, forward flow or reverse flow
●
Current Day total, previous day total and 15 historical day totals
●
Total can be reset to zero by pressing the CLEAR-key twice
TOTAL
Digits
7 digits
Unit
L, m3, US gal, igal, cf, Oil bbl, kg, ton, US ton, lb or none
Decimals
0 – 1 – 2 or 3
Note
Total can be reset to zero
DAILY TOTALS
Digits
7 digits
Unit decimals
According to selection for total
Contract hour
00:00 – 23:00, settable per whole hour
Current day total
Running total, started at zero after the last contract hour
Previous day total
Fixed total, copied from current day total at the last contract hour
Historical day total
The last 15 previous day totals are stored and can be reviewed on the display
Note
Current day total cannot be reset to zero
ACCUMULATED TOTAL
Digits
11 digits
Unit decimals
According to selection for total
Function
Differential total, total A (forward flow) and total B (reverse flow)
Note
Accumulated total cannot be reset to zero
FLOW RATE
Digits
7 digits
Units
mL, L, m3, mg, g, kg, ton, US ton, US gal, igal, Oil bbl, lb, cf, rev, none, scf, nm3, nL or p
Bar graph
speedometer
20 blocks, each block is 5% of total span
Decimals
0 – 1 - 2 or 3
Time units
/sec - /min - /hr - /day
Function
Differential flow
