10.5.2 Add Driver
The add driver button allows you to add a new driver. Refer the the gure below. You will be prompted to enter data for
each of the columns that are displayed on the vehicles page. On the input type you must select whether the entry is a key
or a code (PIN/VIN). Once a driver is added you can edit it from the drivers page by selecting and over typing the entry.
Figure 17: Add Driver Page
10.5.3 Columns
If you select Columns on the vehicles or plant pages you will be presented with the columns conguration page. This page
enables you to change the order of the columns by dragging them up or down the table. The item at the top of the table is
show rst. You can change the column headings by selecting the heading name and then over typing it with the new name.
Headings that are greyed out are set in one of the other conguration screen. You can choose which columns are displayed
by dragging and dropping those required into the left hand site table or remove them by dragging them into the right hand
side table.
10.5.4 Unit Allocation
Allows drivers to be allocated to specic units that report to this website. The default settings is drivers are allocated to all
units. Drivers can be unallocated or allocated to specic units that report to this website
10.5.5 Time of Day Access
Used to set during what periods of time a specic key/code associated with a driver will be able to take fuel. Use Edit
Time of Day List button to edit existing time of congurations or add new ones.
10.5.6 Fill Limits
Sets a ll fuel limit for a specic key/code associated with a driver. This prohibits more than the specied amount of fuel
being dispensed into a given vehicle or piece of plant on a given transaction. . To change the limit click in the Allocation
per Fill eld and either enter the value or over type an existing value.
10.5.7 Daily Allocation
Sets a total daily allocation of fuel for a specic key/code associated with a driver. If this feature is used the daily limit
must be more than the ll limit or the vehicle will be unable to lled to specied limit. The two setting interact and the
lower of the two will be determine how fuel can be taken.
10.5.8 Transaction Input
Use this to select what inputs are request on a per driver basis. The default is all drivers set up for a particular unit to have
any option that has been enabled at the unit The options are:
1. Second ID - Can be a key or code that the driver must use in addition to his primary key or code to get fuel
22
